EasyManua.ls Logo

JVC RX-774RBK - Connecting the FM and am (MW;LW) Antennas

JVC RX-774RBK
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
English
ANTENNA
AM
EXT
AM
LOOP
GND
GND
FM 75
COAXIAL
AM
LOOP
ANTENNA
GND
AM
EXT
GND
FM 75
COAXIAL
AM
LOOP
ANTENNA
GND
AM
EXT
GND
FM 75
COAXIAL
Connecting the FM and AM (MW/LW) Antennas
FM Antenna Connections
Notes:
Make sure the antenna
conductors do not touch any
other terminals, connecting
cords and power cord. This
could cause poor reception.
If reception is poor, connect
an outdoor single vinyl-
covered wire to the AM EXT
terminal. (Keep the AM (MW/
LW) loop antenna connected.)
AM (MW/LW) Antenna Connections
Turn the loop until you
have the best reception.
A
B
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75 COAXIAL terminal as
temporary measure.
B. Using the Standard Type Connector (Not Supplied)
A standard type connector (IEC or DIN45325) should be connected to the FM 75
COAXIAL terminal.
Extend the supplied FM antenna horizontally.
FM Antenna
Outside FM Antenna Cable
Note:
If reception is poor, connect the
outside antenna.
Before attaching a 75
coaxial
cable (the kind with a round wire
going to an outside antenna),
disconnect the supplied FM
antenna.
Snap the tabs on the loop
into the slots of the base to
assemble the AM (MW/
LW) loop.
Outdoor single vinyl-
covered wire
AM (MW/LW) Loop Antenna
AM
EXT
AM
LOOP
GND
GND
ANTENNA
FM 75
COAXIAL
2
3
1
EN01-19.RX-774R[E]/1 98.3.31, 2:00 PM10

Table of Contents

Related product manuals