30
English
TUNER/SEA MEMORY
TUNER PRESET
CH–
Assigning Names to Preset Stations
You can assign a name of up to four characters to each preset station. When a preset
station is tuned in, its assigned name will appear on the display.
On the front panel
only
:
1. Tune in a preset station.
See page 28 for details.
2. Press TUNER/SEA MEMORY.
The preset channel number starts flashing for about 5 seconds.
3. Press TUNER PRESET, while the preset channel
number is flashing.
The first character position starts flashing.
4. Turn MULTI JOG to select a character, while the
first character position is flashing.
You can use characters listed below.
5. Press TUNER PRESET, while a character you want
is flashing.
The next (or previous) character position starts flashing.
6. Repeat steps 4 and 5 to enter up to four characters.
7. Press TUNER/SEA MEMORY while the last selected
character is flashing after you have assigned a name.
To erase the input characters
Insert spaces using the same procedure described above.
MULTI JOG
CH–
CH–
TUNER PRESET
TUNER/SEA MEMORY
Available characters
Space
CBADEGFHIJKLMNO
SRQTUWVX
Y
Z01234P
87695
MULTI JOG
Note:
If you turn MULTI JOG while the
preset channel number is
flashing, you can change
the preset channel number.
Note on step 3 to 7:
You cannot select any entry after
the indication on the display
stops flashing.
In this case, repeat the
procedure from step 2 again.
EN20_51.RX-774R[E]/1 98.3.31, 2:04 PM30
To Next Page
Loading...
