38
Adjusting Sound
You can adjust sound parameters to your preference after completing basic setting.
• When performing the sound adjustments, it is recommended to use the TV screen so that you can show the
on-screen display on the TV.
• When using the buttons on the front panel or remote control without using the on-screen display, you can perform
the same adjustments. (The on-screen display cannot be shown.)
• The on-screen display will disappear if no operation is done for about 1 minute.
Basic Procedure
You can also adjust the sound without showing menus on the TV. For details, see each explanation that follows.
• If Analog Direct is in use, you cannot make any sound adjustments.
• Above items shown on the on-screen display are initial values when shipped from the factory.
• Some of the items cannot be shown or cannot be adjusted. (For details, see the respective explanation in this section.)
Using the on-screen display (through the remote control]:
1. Press MENU.
The MENU screen appears on the TV.
2. Press 5 or ∞ to move to “SOUND CONTROL,” then press 2 or 3.
The SOUND CONTROL menu appears.
3. Press 5 or ∞ to move to select “DIGITAL EQ (Equalization),” “LEVEL ADJUST” or “EFFECT
ADJUST,” then press 2 or 3.
4. Press 5 or ∞ to move
to an item you want to set.
5. Press 2 or 3 to adjust a sound parameter.
6. When you finish, press EXIT repeatedly until the menu disappears from the TV.
MENU
PLAY
STOP
/REW
DOWN – TUNING – UP
FF/
EXIT
PAUSE
SET
CONTROL
On-screen operating buttons
SOUND CONTROL menu
DIGITAL EQ (Equalization) menu
(see page 39)
LEVEL ADJUST menu (see page 40)
EFFECT ADJUST menu (see page 42)
EN38-42.RX-8020V[J]_f 02.3.20, 11:35 AM38
To Next Page
Loading...
Need help?
General
