To Next PageTo Next PageWhat to do if the remote control for my JVC Receiver does not work?
If your remote control is not working, first ensure that the ZONE 1/ZONE 2 selector is set correctly. Also, verify that the TV operation mode selector is correctly set to either “TV” or “CATV/DBS.” Replace the batteries, as weak batteries can cause the remote to malfunction. Finally, ensure that the correct remote control operation mode is selected.
What to do if JVC Receiver display shows flashing “OVERLOAD”?
If “OVERLOAD” starts flashing on the display, it indicates that the speakers are overloaded either due to high volume in Zone 1 or Zone 2, or due to a short circuit in the speaker terminals. First, turn off the receiver by pressing STANDBY/ON on the front panel and stop the playback source. Then, turn the receiver back on and adjust the volume. If the issue persists, turn off the receiver, check the speaker wiring for short circuits. If “OVERLOAD” does not disappear, unplug the AC power cord, then plug it back again. If speaker wiring is not short-circuited, contact your dealer.
Why is there no sound from speakers in Zone 1 of my JVC Receiver?
There might be several reasons why there is no sound from the speakers in Zone 1. Check the speaker wiring and reconnect if necessary. Ensure that the SPEAKERS ON/OFF 1 and SPEAKERS ON/OFF 2/ZONE 2 buttons are set correctly. Verify that the correct source is selected for Zone 1, and that muting is not activated by pressing MUTING to cancel it. Make sure the correct input mode (analog or digital) is selected. Finally, check all connections to ensure they are properly made.
How to fix continuous hissing or buzzing during FM reception on my JVC RX-8040B?
If you are experiencing continuous hissing or buzzing during FM reception, it could be due to several factors. The incoming signal might be too weak, in which case you should connect an outdoor FM antenna or contact your dealer. The station might be too far away, so try selecting a new station. Ensure you are using the correct antenna; check with your dealer to confirm. Also, verify that all antenna connections are properly connected.
General| Frequency Response | 5Hz-100kHz (+0.5dB, -3dB) |
|---|---|
| Dimensions | 420 x 145 x 330mm (W x H x D) |
| Weight | 8.5kg |
| Total Harmonic Distortion | 0.08% |
| Input Impedance | 47k ohms |
| Speaker load impedance | 8 ohms |
| Power Output | 100W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
