39
❏ Changing the transmittable signals for operating
a VCR
1
Press and hold STANDBY/ON VCR.
2
Press VCR.
3
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for VCR” on the right.
4
Release STANDBY/ON VCR.
Now, you can perform the following operation on the VCR.
STANDBY/ON Turn on or off the VCR.
VCR:
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–: Change the channel numbers on the
VCR.
3: Start playback.
7: Stop playback.
8: Pause playback.
FF: Fast-wind a tape.
REW: Rewind a tape.
REC PAUSE: Enter recording pause. To start
recording, press this button then 3.
See the instructions supplied with the VCR for details.
5
Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
Manufacturer Codes
JVC 01
Daewoo 19
Grundig 04
Loewe 03, 05, 06
Nokia 07
Orion 09
Panasonic 10
Philips 03, 11
Samsung 08, 12
Sanyo 02, 07
Sharp 13, 14
Sony 15, 16, 17, 20
Toshiba 18
Initial setting: 01
Manufacturers’ codes for VCR
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
36-40RX-D201S[B]_f.p65 05.5.25, 11:26 AM39
To Next Page
Loading...
