40
Manufacturer Codes
JVC 01
Panasonic 02
Philips 04
Pioneer 03
Sony 05
Toshiba 06
Yamaha 07
Initial setting: 01
Manufacturer Codes
JVC 01, 02
Canal+ 08
Canal Satellite 08
D-Box 11
Grundig 03, 04
ITT Nokia 07
Pace 06, 12, 16
Panasonic 13
Philips 05, 10
Saba 16
Sagem 09, 14
Thomson 16
TPS 09
Wisi 03
Initial setting: 01
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
❏ Changing the transmittable signals for operating
a STB
1
Press and hold STANDBY/ON TV/STB.
2
Press STB CONT.
3
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for STB” below.
4
Release STANDBY/ON TV/STB.
After pressing STB CONT, you can perform the following
operations on the STB.
STANDBY/ON Tu rn on or off the STB.
TV/STB:
CHANNEL +/–: Change the channel numbers on the
STB.
1 – 10, 0, +10: Select the channel numbers on the
STB.
See the instructions supplied with the STB for details.
5
After pressing STB CONT, try to operate your
STB by pressing STANDBY/ON TV/STB.
When your STB turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of STB, try each
one until the correct one is entered.
❏ Changing the transmittable signals for operating
a DVD player
1
Set the mode selector to “DVD.”
2
Press and hold STANDBY/ON DVR/DVD.
3
Press DVR/DVD.
4
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for DVD player” below.
5
Release STANDBY/ON DVR/DVD.
Now, you can perform the following operation on the DVD
player.
STANDBY/ON Turn on or off the DVD player.
DVR/DVD:
3: Start playback.
4: Return to the beginning of the current
chapter (or fast-forward for some
models).
¢: Skip to the beginning of the next chapter
(or fast-reverse for some models).
7: Stop playback.
8: Pause playback.
MENU: Display the menu recorded on DVD
VIDEO discs.
5/∞/3/2: Select an item on the menu screen.
ENTER: Enter the selected item.
1 – 10, 0, +10: Select the chapter number.
See the instructions supplied with the DVD player for details.
6
Try to operate your DVD player by pressing
STANDBY/ON DVR/DVD.
When your DVD player turns on or off, you have entered the
correct code.
Manufacturers’ codes for DVD player
Manufacturers’ codes for STB
NOTE
You cannot use this remote control to operate other
manufacturers’ DVD recorder.
36-40RX-D201S[B]_f.p65 05.5.25, 11:26 AM40
To Next Page
Loading...
