JVL MAC050 - Page 247

JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500 243
5.6 Expansion Mod. MAC00-FC2/FC4/FC41
The drawing below shows the SW3 Dip-switch location. The various settings of SW3 is
shown on the previous page.
Switch description:
The factory default setting is:
SW3 Description Function Signal name
Dip 1 RS232 interface - transmit output ON = Enable Tx
Dip 2
Dip 3
I/O terminal A
DIP2=ON and DIP3=OFF:
AIN (Analogue input)
IOA
Dip 2
Dip 3
I/O terminal A
DIP2=OFF and DIP3=ON:
O2 (output 2)
IOA
Dip 4 I/O terminal B
DIP4=ON: Output 1
DIP4=OFF: Input 1
IOB
Dip 5 I/O terminal C
DIP5=ON: O1 output
DIP5=OFF: PL (positive limit input)
IOC
Dip 6 I/O terminal D
DIP6=ON: O+ (Output supply)
DIP6=OFF: NL (Negative limit input)
IOD
SW3 ON OFF Function
Dip 1 X RS232 interface Enable
Dip 2
Dip 3
X
X
O2 (output 2)
Dip 4 X Input 1
Dip 5 X O1 output
Dip 6 X O+ (output supply)
TT1072GB
M12 Connectors
Dip Switch SW3
placed on the rear
side of the module
Dip switch location on the
MAC00-FC4 Expansion module
Internal circuit boards
SW3
1
2
4
5
6
3
Mini dip-switch
(shown with default setting)
SW3
OFF ON