JVL MAC050 - Page 99

JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500 95
3.2 Power Supply
3.2.12 Power cable accessories for MAC400
The following standard cables can be supplied by JVL
Please use the illustration below when connecting the cables.
Warning: Please notice that it can be fatal connecting 230V to the 115V input.
JVL no. Type Description
WP0002 MAC400 115/230VAC power cable 2 m. Straight M16 conn and free end. Female
WP0005 MAC400 115/230VAC power cable 5 m. Straight M16 conn and free end. Female
WP0020 MAC400 115/230VAC power cable 20 m. Straight M16 conn and free end. Female
WP0102 MAC400 Brake resistor cable 2 m. Straight M16 conn and free end. Male
WP0105 MAC400 Brake resistor cable 5 m. Straight M16 conn and free end. Male
WP0120 MAC400 Brake resistor cable 20 m. Straight M16 conn and free end. Male
WP0402 MAC400 230V power cable with earth 2m. Straight M16 conn and free end. Female
WP0405 MAC400 230V power cable with earth 5m. Straight M16 conn and free end. Female
WP0420 MAC400 230V power cable with earth 20m. Straight M16 conn and free end. Female
Only MAC400
Neutral / 0
Bus Out 325VDC
Neutral / 0
Blue
White
Blue
Red
Yellow
Brown
Brown
Brown
Grn./Yel.
Grn./Yel.
Grn./Yel.
Input 115VAC (phase)
General information:
Make sure that any unused wires are isolated and stay unconnected
Power Dump Output
Input 230VAC (phase)
Common
Input 230VAC (phase)
Earth “ ”
Earth “ ”
Earth “ ”
Input supply cable type: WP0002, WP0005, WP0020
Power dump / DC output cable type: WP0102, WP0105, WP0120
Input supply cable type: WP0402, WP0405, WP0420
TT1194GB