Press the activating push-button.
The visual indicator will turn on, dial tone will be heard for a few
seconds, then the first programmed emergency telephone
number will dial. If busy or there is no answer, the second
number will be dialed, etc.
Once answered, the visual indicator will turn off as Voice
Announcement 1 plays. The visual indicator will then turn back
on and two-way communication will be possible.
NOTE: Voice Announcement 1 will NOT be heard at the K-Phone
ET401 Emergency Speakerphone.
Speak with the called party.
Verify two-way communication and that Voice Announcement 1
was heard clearly; adjust the volume control.
Have the called party press “ # ” (pound).
The visual indicator will start to flash.
When the Timer Minutes runs down to 30 seconds, the
unit will prompt “Press pound for two timer minutes.” The
operator may keep the K-Phone ET401 Emergency
Speakerphone on for an additional two minutes by hitting
(pound) on their telephone keypad.
Have the called party hang up.
The K-Phone ET401 Emergency Speakerphone will
automatically shut off via the telephone line disconnect (CPC)
signal.
NOTE: If this signal is not present on the line, the K-Phone
ET401 will shut off via the timer, or the called party can hit
(star pound) on their telephone keypad to turn the phone
Have the answering party call back to the K-Phone ET401
Emergency Speakerphone.
It will ring the selected number of rings, then automatically
answer the incoming call and allow two-way communication.
Have the called party press “ * 1 ” (star one).
Voice Announcement 1 will replay.
Finish mounting the K-Phone ET401 and retest.
NOTE: Make sure wiring does not physically interfere with
components when finalizing installation.
To Next Page
Loading...
General