K-Tech ET401A - Model Installation Guides; Sentry (ET401 A) Mounting

Page 7
Installation
Sentry (ET401A)
1.
Use the 3/32” Allen wrench (included) to unscrew the fasteners
and remove the rear enclosure.
2.
Using the rear enclosure as a template, mark the mounting
screw hole locations.
3.
Drill holes for two #8 screws (included).
4.
Mount the rear enclosure placing the Ground Lug under one of
these mounting screws.
WHEN LIGHT
FLASHES
HELP IS ON
THE WAY
K-Tech International, Inc, Torrington, CT
5.
Proceed to Settings on page 11.
6.
Proceed to Programming on page 12.
7.
Proceed to Operation and Testing on page 16.