K2 Pumps SPP03301K - Pre-Installation; Application; Tools Required; Materials Required (Not Included)

For Professional Technical Support call 1-844-242-2475 3
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long
time when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or
debris may cause the pump to fail. Please carefully read the manual and follow the instructions regarding
common pump problems and remedies.
PRE-INSTALLATION
APPLICATION
 The non-submersible pedestal sump pump is designed for sump water removal applications. It is not engineered
to be run continuously as a “fountain” or “waterfall” pump.
TOOLS REQUIRED
MATERIALS REQUIRED (NOT INCLUDED)
NOTE: Parts shown below not to scale.
Flathead
Screwdriver
Safety goggles
Tape Measure
Channel
Locks
Pipe wrench
Cable Ties
Hacksaw
Thread Tape
1-1/4”
or 1-1/2”.
check valve
Threaded Adapter
(Pipe to Pump)
1-1/4’’ or 1-1/2’’
ABS or PVC Pipe
ABS or PVC Cement
(to match the pipe)
1-1/4”. or 1-1/2”.90°
Elbow
Phillips
Screwdriver