For Professional Technical Support call 1-844-242-2475 7
1. Connect the Suction Strainer and
Suction Hose
Attach the Suction hose included with your pump to the
Suction Strainer. Make sure the gaskets in the Suction
hose are airtight or the pump will not pump water.
Lay the pump on its side and open the bottom cover.
Attach the other end of the Suction hose to the pump
inlet.
2. Attach the Garden Hose
Attach a 3/4 in. garden hose to the pump outlet. Use
a garden hose that is no longer than 25 ft. Keep both
the Suction hose and Garden hose as straight as
possible. The end of the Garden hose should be
OUT of the water.
3. Prime the Pump
Unscrew the priming plug. Fill with water until the
suction hose is completely filled and overflowing with
water. Tighten the priming plug.
To Next Page
Loading...
