K2 Pumps UTS03301K - PRE-INSTALLATION REQUIREMENTS; APPLICATION, TOOLS, AND SPECIFICATIONS

For Professional Technical Support call 1-844-242-2475 3
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.
20. This pump does not require a connection to a main stack vent, per the National Standard Plumbing Code (NSPC)
2003 Section 11.7.9.
PRE-INSTALLATION
APPLICATION
This pump is designed to be used with a sink where a gravity drain line is not available. Attach the pump to the drain tail
piece; the pump will start when water begins to drain. Uses include basement laundry sinks, wet bars and utility sinks.
TOOLS REQUIRED
SPECIFICATIONS
Power supply
115V, 60 HZ., 15 Amp Circuit
Liquid temp. range
32 to 95°F (0- 35°C)
Pump Inlet
1-1/2 in. NPT
Pump discharge
1-1/4 in. NPT
Phillips
Screwdriver
Flathead
Screwdriver
Safety
goggles
Tape
Measure
Channel
Locks
Pipe wrench
Hacksaw