Kaadas S100C - Access into Master Mode; Change Master PIN Code; Enroll User PIN Code

Default master
PIN code is
12345678.
Access into master mode
Change master PIN code
1. Wake up touchscreen keypad with palm.
2. Press [*] twice, input master PIN code, and press [#]
to confirm.
3. Voice guide: Enter the Master Mode.
Note: Change default master PIN code is required
immediately for menu operation.
In master mode
Press 1 to user setting, then press 9 to change default
master PIN code.
Enter new master PIN code, press # to confirm. Reenter
the master PIN code, then press # to confirm. Voice
prompt of "Set up succeeded"
User Setting
Enroll user PIN code
Access into master mode
Enroll Fingerprint (only available for S100C-5)
Access into master mode
Enroll Card
Access into master mode
Press [1] for user setting.Then press [1] to enroll user
PIN code. Enter 2 digital user number (00-09), and
confirm with [#] key
Press [1] for user setting.Then press [2] to enroll user
fingerprint. Enter 2 digital user number (00-99), and
confirm with [#] key.
Place your finger on the fingerprint sensor, then take
away your finger after voice prompt "Remove finger
and scan again". Repeat above steps multiple times
until voice prompt "Enrollment succeed".
Enter user PIN code (6-12 digits), and confirm with [#]
key; Then repeat above operations .
Voice prompt of "Enrollment succeed"