Kalkhoff Pedelec Impulse

VI User Manual | Impulse Ergo Pedelec 17
› Damaged batteries may not be charged, and
rther use is not permitted.
› The battery may heat up during charging. A maxi-
mum temperature of 45°C may be reached. If the
battery becomes any warmer than this, suspend
the charging process immediately.
4.4 Fitting the battery
1. Insert the battery into the battery holder of the Pe-
delec om the le by tilting it outwards at roughly
45°. In doing so, make sure that the lateral guides at
the bottom of the battery are also inserted into the
guides in the holder.
2. Tilt the battery towards the bike until it engages in the
locking mechanism. If the key is still in the lock, turn it
clockwise then pull it out to lock the battery in place.
3. Make sure the battery is rmly in place.
Reinstalling the battery
5 Control panel and display
5.1 Basic nctions
Control panel
• On the le, you will nd the
1
upper and
3
lower arrow buttons. The buttons have dier-
ent nctions depending on the item of the settings
menu at which you are located.
• Between the arrow buttons is the
2
Set button. It
can be used to request a variety of displays.
• The
4
pushing assistance is located at the top
on the right. This moves the Pedelec slowly (at a
maximum speed of 6 km/h) without you having to
turn the pedals.
• The
5
power button is located at the bottom on
the right. This can be used to turn the system on
and o again.
1 Upper arrow button
(more powerl assistance)
2 Set button
3 Lower arrow button
(less powerl assistance)
4 Pushing assistance
5 Power button
1
4
5
2
3