EasyManuals Logo

Kalkhoff Pedelec Impulse User Manual

Kalkhoff Pedelec Impulse
230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
38 I General User Manual
Cleaning
Whenever possible, avoid using cleaning agents on
the chain. If you use cleaning agents, such as rust
remover, this may wash lubricant out of the chain
which could lead to malnctions.
The chainrings and sprockets should be cleaned
regularly using a neutral cleaning agent.
You should clean the derailleur and lubricate the
moving parts (mechanism and rollers) at regular
intervals.
19.2 Hub gears
This User Manual describes the handling of typical, com-
mercially available gear-shi components of a gear hub on
a city or trekking bike. For other components, refer to the
separate information or enclosed instructions.
If you have questions on installation, adjustment, main-
tenance and operation, please consult a specialist cycle
shop.
If the hub is mounted on the ame, the correct x-
ing washers must be used on both sides and the hub
nuts must be tightened to the prescribed torque (see
Chapter 30 "Technical data").
If the xing washers are used on one side only or the
hub nuts are tightened incorrectly, the hub may mal-
nction: It could rotate. This could cause the shiing
cable to pull the handlebar to one side and cause a
serious accident.
The gears can be changed when the pedals are turn-
ing. Very occasionally, the hub may produce a harm-
less noise which is caused by its internal cogs and
stop notches.
If you encounter resistance when turning the wheel,
the brake pads will need to be replaced or the hub
will need to be lubricated. This should be done by a
professional bike workshop.
If the chain jumps o the the sprockets when you are
riding, the slack in the chain must be taken up imme-
diately. If there is no rther scope for adjustment, the
sprockets and chain must be replaced.
19.2.1 Operating the hub gears
19.2.1.1 Shimano 7/8-speed shi lever
Turn the twist-shi lever to select all 8 (7) gears.
Increasing pedal force (increasing resistance)
indicator towards 8 (7)
Indicator
Display
Revo-shi lever
Decreasing pedal force (decreasing resistance)
indicator towards 1
These instructions on operation of the Shimano twist-shi
grips also apply for other makes of twist-shi grips.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kalkhoff Pedelec Impulse and is the answer not in the manual?

Kalkhoff Pedelec Impulse Specifications

General IconGeneral
BrandKalkhoff
ModelPedelec Impulse
CategoryBicycle
LanguageEnglish

Related product manuals