Kalkhoff Pedelec Impulse User Manual

I General User Manual 37
Rear derailleur
Have your specialist cycle shop carry out maintenance
on the derailleur gears, or replace or adjust them.
Precision adjustment / rear derailleur
Operate the shiing lever to shi the chain om the small-
est sprocket to the second sprocket. Then take up the
slack in the shiing cable with the shiing lever and turn
the crank.
Adjustment
screw
If the chain
jumps to the third
sprocket:
› Turn the adjustment screw clockwise until the
chain moves back onto the second sprocket.
Adjustment
screw
If noises cannot
be heard:
› Turn the screw anticlockwise until the chain rubs
against the third sprocket.
The adjustment screw may also be on the shiing
lever or on the ame.
A
B
Adjustment screw
Cable housing adjustment screw
Optimum adjustment
Once the slack in the shiing cable
has been taken up by the shiing
lever, the chain should ideally rub
the third sprocket and produce a
noise.
Release the shiing lever in second
gear and turn the crank.
If the chain rubs the third sprocket, turn the adjustment
screw clockwise slightly until the grinding noise stops.
To ensure problem-ee SIS operation, you will need to
lubricate all power-transmitting parts.
If the chain is in the position shown, it could rub
against the chainrings or the ont derailleur and
make a noise. If this is the case, you can shi the
chain onto the second or next largest sprocket.
Chainrings
Sprockets

Kalkhoff Pedelec Impulse Specifications

General

Brand	Kalkhoff
Model	Pedelec Impulse
Category	Bicycle
Language	English