Kalkhoff Pedelec Impulse - Device Settings; Display; Drive

Original User Manual | Pedelec Impulse 2.0 19
Brightness: You can select the following values using the
/ button:
Very bright -50%
45%
40%
35%
30%
Average "Standard"
5%
10%
15%
Very dark 20%
The change in brightness is implemented immediately.
Pressing the
button conrms your selection and then
takes you back to the menu sub-item display.
Language: You can choose to have the information shown
on the display in the following languages:
• Deutsch
• English
• Francais
• Nederlands
• Espanol
• Italiano
• Suomi
• Dansk
You can select the relevant language using the
/ but-
tons. Tapping the
button conrms your selection and
takes you back to the menu sub-item display.
Unit: Under the item “Unit”, you can choose whether in-
formation on distance travelled and speed is displayed
in kilometres (km) or miles (mi). Use the
/ buttons to
choose between kilometres (km) or miles (mph). Tapping
the
button conrms your selection and then takes you
back to the menu sub-item display.
7.4.4.2 Drive
Choose om the following using the
/ button:
• Wheel circumference
• Shi Sensor
• Climb Assist
• Back
Conrm your selection by tapping the
button. You are
taken back to the menu sub-item display.
it “Yes” or “No”. Select the desired item using the
/
button. The selection is highlighted in bold. Conrm your
selection by tapping the
button. You are taken back to
the menu sub-items.
7.4.4 Device settings
Under the menu sub-item “Device settings”, you can select
the following items by pressing the
/ button:
• Display ➠ Chapter 7.4.4.1
• Drive ➠ Chapter 7.4.4.2
• Miscellaneous ➠ Chapter 7.4.4.3
• Back
Conrm your selection by tapping the
button.
7.4.4.1 Display
Choose om the following using the
/ button:
• Contrast
• Brightness
• Language
• Unit
• Back
Conrm your selection by tapping the
button.
Contrast: You can select the following values using the /
button:
Very low contrast -35%
-30%
-25%
-20%
-15%
-10%
-5%
Average "Standard"
5%
10%
15%
Very high contrast 20%
The change in contrast is implemented immediately. Tap-
ping the
button conrms your selection and then takes
you back to the menu sub-item display.