English–6
Bosch eBike Systems 0 276 001 SPI | (22.8.13)
Power Supply of External Devices
via USB Connection
With the USB connection, it is possible to operate and charge
most devices whose power supply is possible via USB (e.g.,
various mobile phones).
Prerequisite for the charging is that the HMI and a sufficiently
charged battery pack are inserted in the eBike.
Open the protective cap 8 of the USB port on the HMI. Con-
nect the USB port of the external device to the USB socket 7
on the HMI using a standard-compliant Micro A/Micro B USB
2.0 cable. Using a USB cable that is not standard-compliant or
a cable/adapter combination can lead to damage to the HMI.
530
Battery pack error Switch off the e-Bike, remove the battery pack and reinsert the battery
pack. Restart the system. If the problem persists, contact your Bosch
eBike dealer.
531
Configuration error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
540
Temperature error The eBike is outside of the permissible temperature range. Switch off the
eBike system and allow the drive unit to either cool down or heat up to the
permissible temperature. Restart the system. If the problem persists,
contact your Bosch eBike dealer.
550
An improper load was detected. Remove load. Restart the system. If the problem persists, contact your
Bosch eBike dealer.
602
Internal battery pack error while
charging
Unplug the charger from the battery pack. Restart the eBike system. Plug
the charger into the battery pack. If the problem persists, contact your
Bosch eBike dealer.
602
Internal battery pack error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
603
Internal battery pack error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
605
Battery pack temperature error The eBike is outside of the permissible temperature range. Switch off the
eBike system and allow the drive unit to either cool down or heat up to the
permissible temperature. Restart the system. If the problem persists,
contact your Bosch eBike dealer.
605
Battery pack temperature error while
charging
Unplug the charger from the battery pack. Allow the battery pack to cool.
If the problem persists, contact your Bosch eBike dealer.
606
External battery pack error Check the wiring. Restart the system. If the problem persists, contact
your Bosch eBike dealer.
610
Batter pack voltage error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
620
Charging error Replace the charger. Contact your Bosch eBike dealer.
640
Internal battery pack error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
655
Multiple battery pack errors Switch off the eBike system. Remove the battery pack and reinsert it.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
656
Software version error Contact your Bosch eBike dealer so that he can perform a software
update.
No display
Internal error of the HMI Restart your eBike system by switching it off and back on.
Code Cause Corrective Measure
OBJ_BUCH-2087-001.book Page 6 Thursday, August 22, 2013 11:11 AM
To Next Page
Loading...
Need help?
General
