33
PBHOld ON | OFF
Default ON
When ON, any message received over the radio will automatically be held by your PBBS for you to
review. You may then release the message for forwarding by editing it and changing the H flag
(for example, to edit message number 4: E 4 H). When OFF, messages received over the radio are
not held, but may immediately be forwarded from your PBBS. (Note that any message addressed
TO or @ your MYCALL or MYPBBS call will be held regardless of the setting of PBHOLD.)
PBKillfw ON | OFF
Default ON
When ON, private and traffic messages will be killed (deleted) from your PBBS automatically after
they have been forwarded to another BBS. When OFF, these messages will not be killed, but will
be marked with the forwarded flag (F) to prevent them from forwarding again.
PBList [ON | OFF][NONE | {+ | -}callsign | callsign,callsign,...] v8.2
Default OFF NONE
If ON, PBBS considers list as family.
PBLO [OLD | NEW] [FIXED | VARIABLE]
Default NEW VARIABLE
When set to NEW, the PBBS will list messages to a user with the newest message (highest num-
ber) listed first. When set to OLD, the oldest message will be listed first. When the second parame-
ter is set to VARIABLE, the user may change the order of the listing by using the LO command in
the PBBS. When set to FIXED, the user cannot change the listing order.
PBPerson ON | OFF
Default OFF
When OFF, your PBBS will accept messages addressed to any station. If the message is then for-
warded to another BBS, your PBBS will add an R: line indicating that the message was forwarded
by your system. When ON, your PBBS becomes a PERSONAL system. This means that it will only
accept messages addressed to your MYCALL or your MYPBBS call. In addition, the PBBS will only
forward messages to another BBS if they are FROM your MYCALL. When forwarding or reverse for-
warding with PBPERSON ON, the PBBS will not include its own R: line.
PBRevers ON | OFF
Default OFF
When OFF and your KAM initiates a forward (PBFORWRD command) it will send all eligible mes-
sages to the other BBS. After all messages have been sent, the KAM will then disconnect from the
other station.
When ON, the KAM will poll the other BBS for any messages after it has forwarded the KAM mes-
sages to the other BBS and before disconnecting.
To Next Page
Loading...
