37
RBaud
n
(
n
= 20 – 500)
Default 45
This command sets the Default baud rate used when entering RTTY mode. It also sets the baud
rate used for RTTY operation if PMODE is RTTY. When operating in the RTTY Mode, typing the
[Ctrl-C][0] directive will also switch to the RBAUD rate.
See also: pmode, rtty
REdispla
n
(
n
= $00 – $FF)
Default $12 (Ctrl-R)
This command is used to change the REDlSPLAY-packet input editing character. The parameter
n
is
the ASCII code for the character you want to type in order to redisplay the packet currently being
entered. You can use the REDlSPLAY-packet character to see a "clean" copy of your input if you
are using a printing terminal for have BKONDEL OFF and you have deleted characters. The redis-
played packet will show the corrected text.
See also; bkondel, canline, canpac, flow
RELink ON | OFF
Default OFF/OFF
When OFF and operating PACKET using the Level 2 Version 2 protocol (see AX25L2V2), the KAM
Plus will not attempt to automatically reconnect when data has not been acknowledged and a dis-
connect occurs. When ON, the KAM Plus will attempt to reconnect if the RETRY count has been ex-
ceeded.
See also: ax25l2v2, retry, tries
REPhase ON | OFF
Default ON
When ON and operating Mode A AMTOR, the KAM Plus will automatically attempt to rephase with
the other station if repeated errors occur. When OFF, repeated errors will cause the KAM Plus to re-
turn to AMTOR Standby mode.
RESET
Immediate command
This command performs a soft reset of the KAM Plus. Any existing connections will not be recog-
nized, but your parameter settings and messages in the mailbox will not be disturbed. The Kant-
ronics sign-on message will be displayed.
See also: intface, maxusers, myremote, navsta, numnodes, pbbs, pmode, port, restore
RESPtime
n
(
n
= 0 – 255) Not in v8.2
Default 15
When connected to another PACKET station, your KAM Plus will send an acknowledgment for a re-
ceived information packet after
n
× 100 milliseconds. This command is useful in avoiding collisions
during such activity as file transfers using full-length packets. If operating half-duplex, this timer is
suspended whenever the PTT line is active, or when carrier detect is present.
See also: frack
To Next Page
Loading...
