39
SCreenl
n
(
n
= 0 – 255)
Default 0
This value is used to format data sent to your terminal. A carriage return sequence is sent to the
terminal at the end of a line when
n
characters have been printed. A value of 0 inhibits this action.
See also: autolf
SEndpac
n
(
n
= $00 – $FF)
Default $0D (
ø
)
This command specifies a character that will force a packet to be transmitted in Convers Mode. In
the Convers Mode, packets are sent when the SENDPAC character is entered or when PACLEN is
achieved.
See also: cpactime, cr
SHift 170 | 425 | 850 | MODEM
Default 170
This command sets the Default shift used in RTTY, ASCII, AMTOR, NAVTEX and PACTOR Modes.
When MODEM is specified, the MARK and SPACE commands set the frequencies used by adjusting
the switched capacitance filters in the KAM Plus. The MARK and SPACE settings are always used
for the HF PACKET tones and when operating G-TOR. When operating in a non-packet mode, the
[Ctrl-C][S] directive may be used to change shifts.
See also: mark, space
SLottime
n
(
n
= 0 – 255)
Default 5/10
Sets the time between successive tries of the persistence algorithm to
n
× 10 milliseconds.
See also: persist
SPace
n
(
n
= 50 – 4000)
Default 1800
This command sets the space frequency used for HF packet operation and (if the shift command is
set to MODEM) for non-packet modes. The SPACE command must be set greater than the MARK
command.
See also: mark, shift
STart
n
(
n
= $00 – $FF)
Default $11 (Ctrl-Q)
This command specifies the character sent by the terminal to the KAM Plus to restart input from
the KAM Plus. If set to $00, only hardware flow control will be used. For software flow control, set
this parameter to the character the computer will send to restart data flow and be sure XFLOW is
ON.
See also: stop, xflow, xoff, xon
To Next Page
Loading...
