7
AXHang
n
(
n
= 0 – 255)
Default 0
When operating through a voice repeater, this command should be set to the hang time of the re-
peater. If the KAM Plus has detected activity within this time interval, it will not use the AXDELAY
setting, since the repeater should still be transmitting. Each unit represents 10 milliseconds.
Beacon (Every | After)
n
(
n
= 0 – 255)
Default Every 0/Every 0
When set to EVERY, a beacon packet will be transmitted every n minutes. When set to AFTER, a
beacon packet will be transmitted ONCE after n minutes of no channel activity. Setting n to Ø will
disable beacon transmissions.
See also: btext
BER v8.2
In use BER test (???)
BIts
n
(
n
= $00 –$FF)
Default $00
This command specifies the bits to be inverted when receiving a RTTY or ASCII signal. This may
enable you to decode some scrambled RTTY/ASCII signals. Transmitted RTTY and ASCII is not af-
fected by this command.
BKondel ON | OFF
Default ON
When ON, the KAM Plus will echo a backspace-space-backspace sequence to your terminal when
the DELETE character is received from the terminal. When OFF, the KAM Plus will echo a backslash
character ( \ ) when the DELETE character is received.
See also: delete, redisplay
BLt
n
EVERY | AFTER hh:mm:ss [START hh:mm:ss] (
n
= 1 – 4) v8.0
Default EVERY 00:00:00/EVERY 00:00:00
This command sets the interval between beacons for the associated string.
n
identifies which LT is
used (1 – 4). If EVERY is specified, the LT will be transmitted at the interval specified by the
hh:mm:ss parameter. This is set in hours:minutes:seconds, and all characters must be specified.
The values before the / apply to the HF port and the values after the / apply to the VHF port. If
the optional key word START is given followed by a time (in 24 hour format), the beacons will not
be transmitted until the specified time. The beacon will then be transmitted according to the set-
ting of the EVERY parameter. (NOTE: If the current time is past the start time, the beacon will
start at the next scheduled interval based on the start time.)
If AFTER is specified, the beacon will be transmitted once after no activity is detected on the chan-
nel for hh:mm:ss time. Selecting AFTER does not allow the optional START parameter.
For example, setting BLT3 EVERY 00:15:00 START 03:30:00 would cause the third string (LT 3) to
be transmitted every 15 minutes, with the first transmission each day occurring at 03:30:00.
BReak ON | OFF v8.2
Default OFF
If ON, a modem break will cause return to Command Mode.
To Next Page
Loading...
