KPC-9612 Version 5.2 July 19, 1994
36
PBBS
n
(
n
= 0 – 500 [depending on RAM]) {5 (32 K version); 100 (128 K version)}
This command sets the size of the KPC-9612 Personal mailbox (in Kilobytes). The maximum value
will depend on the amount of RAM available for the mailbox. The amount of RAM will also depend
on the settings of MAXUSERS and NUMNODES, and will be affected by enabling the MYREMOTE.
Changing the size of the PBBS will not affect the contents of the mailbox as long as sufficentme-
mory remains allocated to store the existing messages.
To renumber the messages in your PBBS, give the PBBS command with
n
being the same as the
current size of the PBBS.
See also: mypbbs, setting up other functions section
• PBForwrd bbscall [VIA calll, call2,..., call8] [PORT 1|2] [Every
n
|After
n
]
[NONE PORT 1 EVERY 0]
This command will cause your PBBS to attempt to initiate a forward of any eligible mail to another
BBS system periodically. Any message in your PBBS which contains an ©BBS field and is not being
HELD (H) or has not previously been FORWARDED (F) is eligible to forward. If the keyword EVERY
is used, the PBBS will attempt to forward once every
n
hours. If you specify the keyword AFTER,
the PBBS will attempt to forward whenever a user disconnects from the PBBS and every
n
hours
after that. Setting the time interval will cause the PBBS to attempt to forward immediately. After
the PBBS has forwarded any messages, it will request a reverse forward if the PBREVERS com-
mand is ON.
NOTE: If PBPERSON is OFF, the PBBS will not forward or reverse forward forward unless HTEXT is
set.
See also: htext, pbperson, pbrevers, pbbs section
• PBHeader ON|OFF {ON}
When ON, the routing headers received from a BBS will be stored in the PBBS mailbox. When OFF,
these headers are not stored in the mailbox, allowing messages to require considerably less space.
The routing headers are those lines you normally see in messages beginning with R: until it sees
the first line that does not have R: in column one. From that point on, all of the message. The
PBBS will ignore all lines beginning with R: until it sees the first line that does not have R: in col-
umn one. From that point on, all of the message will be stored, even if a line begins with an R:.
NOTE: If you have your PBBS set to initiate forwarding or you are polled by another BBS for re-
verse forwarding, we recommend leaving PBHEADER ON.
• PBHOld ON|OFF {ON}
When ON, any message received over the radio will automatically be held by your PBBS for you to
review. You may then release the message for forwarding by editing it and changing the H flag
(for example, to edit message number 4: E 4 H). When OFF, messages received over the radio are
not held, but may immediately be forwarded from your PBBS. (Note that any message addressed
TO or @ your MYCALL or MYPBBS call will be held regardless of the setting of PBHOLD.)
See also: pbbs sysop functions section
To Next Page
Loading...
Need help?
General
