Kapture KPT-522 - MANUAL POWER OFF; RESET THE CAR DVR; INITIAL SETTINGS; FORMATTING THE INSERTED MICRO SD CARD

20
5.3 MANUAL POWER OFF
Make sure that recording has been stopped and then press the Power button
on the lower right hand side of the car DVR. After powering down the device please
wait for 10 seconds before turning the Car DVR back on.
5.4 RESET THE CAR DVR
If the Car DVR does not function normally, try restarting the car DVR. To restart
the car DVR, using a small pin press and hold the Reset button on the bottom side
of the camera.
6.0 INITIAL SETTINGS
Before using the Car DVR we recommend Formatting the Inserted Micro SD Card
and setting the correct Time and Date.
6.1 FORMATTING THE INSERTED MICRO SD CARD
Formatting the Micro SD card will delete all information on the inserted Micro SD
Card and prepare the card for use with the Car DVR.
1. Press the Button to stop the Car DVR from recording.
2. Press the Menu Button to enter the Settings Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the
Format setting and press the right to select.