Kärcher CV 38/2 Manual

12 English
Storage
몇 CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
The device may only be operated indoors.
Care and service
 DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Maintenance intervals
ATTENTION
Risk of damage
Please adhere to the specified maintenance intervals in
order to prevent damage to the device.
Daily
1. Clean the roller brush.
Weekly
1. Check the roller brush for wear.
Note
The degree of wear can be determined by comparing
the differently coloured indicator tufts. Replace the roller
brush when the black bristles are the same height as the
red bristles.
Cleaning the roller brush
1. Remove the brush cover if necessary: Use a coin to
turn the rotary lock by 90° and remove the brush
cover.
2. Cut off hair and threads wound onto the roller brush
using scissors and remove them.
Changing the filter bag
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to unlock. Close
the filter bag, remove and dispose of it.
3. Insert a new filter bag and turn the filter bag lock to
the left to lock.
4. Fit and lock the filter cover.
Replacing the exhaust filter
1. Unlock and remove the filter cover.
2. Push the filter casing locking mechanism upwards
and remove the filter casing.
3. Remove the exhaust filter from the filter casing.
4. Insert a new exhaust filter in the filter casing.
5. Insert the filter casing and latch it into place.
6. Fit and lock the filter cover.
Replacing the motor protection filter
1. Unlock and remove the filter cover.
2. Press the motor protection filter lock upwards. Re-
move the old motor protection filter and dispose of it.
3. Fit and lock the new motor protection filter.
4. Fit and lock the filter cover.
Replacing the roller brush
Please make sure that the bracket is always completely
opened during installation.
1. Fold the bracket on the side section fully upwards
and remove the side section.
2. Pull out the old roller brush and dispose of it.
3. Insert a new roller brush in the side section.
4. Push the side section together with the roller brush
into the device.
5. Fold the bracket fully downwards to lock the side
section.
Troubleshooting guide
 DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.

Kärcher CV 38/2 Specifications

General

Motor power	- W
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Maximum input power	850 W
Annual energy consumption	37.4 kWh
Airflow	40 l/s
Product type	Upright vacuum
Dust capacity	5.5 L
Product color	Black, Grey
Tube material	-
Dust container type	Dust bag
Standard nominal width	- mm
Noise level	80 dB
Cleaning surfaces	Carpet
Vacuum air filtering	HEPA
Dirt separating method	Filtering
Working width (standard brush)	380 mm
Cord length	12 m

Weight and Dimensions

Depth	391 mm
Width	351 mm
Height	1215 mm
Weight	9500 g
Weight (without accessories)	8700 g