· Sounds&Alerts
o Signal Beep Option
o Keypad Sound
o Ringer Volume
o Microphone Volume
o Ring Tone
o Ring Cadance
· Price
o Meter Pulse Price
o Last Call
· Home Area Code
· Line Access Code
· Enblock
Key Settings
Number of keys that can be programmed is 16 in total and assignments of programs
are done to those. In case the user presses those keys continuously for one second,
the second function of the key is detected. Therefore, total number of features that can
be programmed becomes 32. During programming, the LED that belongs to the keys
signifies to which key and to which function of the key the assignment is done by
lighting in two colors. When the LED is observed to be lighting in green by pressing the
key until the single short beep is received, the first function will have been assigned
and the second function will have been assigned when the LED is observed to be
lighting in red by pressing the key until the short beep is received for the second time
(for 1 second.) The keys become active after the programming mode is exited
The assignments performed on these keys cannot be cancelled one by one; however,
new assignments can be done to them without encountering the error signal.
Cancellation of contents of the programmable keys can be carried out by selecting
Phone Settings > Key Settings > Auto Setting> Clear All.
Extension
The user can reach an extension that is called frequently through a single key by
programming her/his number on that key. In order to do that, one first proceeds to the
programming menu.
¨ Press Key: The key, on which the programming will be done, is pressed for a
short or a long period in order to select the first or the second function,
respectively.
¨ No: Then the “no=”menu comes to view. In this menu, the display cursor enables
data entry. After the user enters the extension number by using the numeric
keypad, s/he confirms the extension number s/he has entered by pressing the
“Accept” key. The user can enter an extension number with at most 8 digits.
To Next Page
