Karma Ergo 2 Series - Maintenance

30
4.6.2 Adjusting the length of a pelvic belt
1. Identify the required length of the pelvic belt. (See Figure 4.33.)
2. Push the two part of belt through buckle to make the belt longer or shorter. (See
Figure 4.34.)
3. Pull the two part of belt tight. (See Figure 4.35.)
4. Push buckle up to the plastic clip so that the belt cannot slip out of position.
Please check that there is no gap between the clip and buckle.
NOTE
We recommend that the pelvic belt is fitted quite tightly around the pelvis. Please tighten
until you can just get your fingers between the user and the pelvic belt. Please check
that the pelvic belt is fastened correctly as recommended. If this is not possible, please
consult your supplier.
Figure 4.33
Figure 4.34
Figure 4.35
4.6.3 How to operate a pelvic belt
1. When you sit on the wheelchair, fasten the pelvic belt.
2. Adjust the pelvic belt and make it fit your body for comfort and security.
3. When you don’t use it, please fasten the pelvic belt to avoid the belt dropping into
rear wheels during motion.
4.6.4 Maintenance
The pelvic belt is made from 100% polyester fiber and the clasp is made from plastic. It
does not require any maintenance but should be inspected every month to ensure that
the edges are not frayed and weekly to make sure that it correctly fits the user. If there
are any signs of deterioration, please replace it immediately.