●If the back angle of the wheelchair is adjustable, do make sure that the
wheelchair backrest should be positioned as close as possible to 90
degrees.
5.26.1 Please detach all easily removable accessories from the
wheelchair and stow them in a safe place where they cannot
move around and become a safety hazard.
5.26.2 A four point tie-down system should tightly fasten to the lower
wheelchair frame marked with a yellow sticker as pictured.
5.26.3 An occupant restraint system using both a pelvis and
harness must also be fastened to the transport vehicle
to insure user safety. Please refer to the restraint
system's instructions.
5.26.4 The attendant / transporter must double-check all fastening
points for proper connection and tightness to assure the
wheelchair users safety. The attendant / transporter must be fully
cognisant of the fastening system's usage and its weight
limitations.
5.26.5 See http://www.unwin-safety.com/ for more information
5.27 Method of Restraint
5.27.1 KP-20.2 and KP-25.2 were tested with four point webbing
systems, with the back in the upright position. Please refer to the
restraint manufacturer’s user guide for further details of its
operation.
5.27.2 Fitting the front restraint
5.27.2.1 Connect the straps around the wheelchair frame and caster
bracket as pictured below. The anchor point is marked with a
yellow sticker.
To Next Page
Loading...
Need help?
General
