Correct seat belt position
Incorrect seat belt position
●When transporting or lifting, never hold on to attachments or accessories
(front casters, drive wheels, handrims, footrests, armrests, anti-tippers etc.)
●All lifting should be done with a straight back. Straight legs to lift the chair.
Carefully carry it up or down steps; be aware of how you place your feet, do
not cross them and trip yourself up.
5.29 Adjusting the length of the pelvic belt
5.29.1 Identify the require length of the belt. (Figure 5-13)
5.29.2 Push the two part of belt through buckle to make the belt longer
or shorter. (Figure 5-14)
5.29.3 Pull the two parts of belt tight. (Figure 5-15)
5.29.4 Push buckle up to the plastic clip so that the belt can not slip out
of position. Please check that there is no gap between the clip
and buckle. (Figure 5-16)
● We recommend that the belt is fitted quite tightly around the pelvis.
Please tighten until you can just get your fingers between user and seat
belt. Please check that the belt is fastened correctly as recommended. If
this is not possible please consult your supplier.
To Next Page
Loading...
