3 – 32
MAINTENANCE
3-11 LONG TERM STORAGE
Before Storage
To protect the cylinder rods, set the machine
position in the right illustration.
(To prevent the cylinder rods from being rusted )
To store the machine from long term, follow the next
procedures.
• Clean parts of the machine and store indoors.
If you have to place the machine outdoors,
choose a flat place and cover the machine.
• Be sure to perform fill the fuel, lubrication, and oil
change.
• Apply grease on the exposed part of the hydraulic
cylinder piston rods.
• Store the battery after move the negative terminal
and covering it or dismounting the battery from the
machine.
• Lock the control levers and pedals with the lock
lever and pedal lock.
During Storage
If you have to operate the machine indoors to
prevent rust, keep good ventilation and gas
poisoning by window or entrance.
During storage, operate the machine once a month
to maintain films of oil at the lubrication section and
charge the battery at the same time.
After Storage
After long term storage, follow the next procedures
before operating the machine.
• Wipe away grease on the hydraulic cylinder rods.
• Be sure to perform fill the fuel and lubrication.
WARNING
Bucket position at the time of
long term storage.
To Next Page
Loading...