2 – 12
OPERATION
2-3 BEFORE STARTING THE ENGINE
The following items should be checked each day before start-up
or the start operations.
Walk-Around Inspection
Inspect the loose bolts, trash build up, oil or
coolant leaks, broken or worn parts. Inspect the
condition of the attachments and the hydraulic
components.
Inspect the operator’s compartment for cleanliness.
Keep it clean.
Inspect any cracks in boom and arm pivot area and
cylinder mounting brackets.
Repair if damaged.
Refer to Walk-Around Inspection in the
Maintenance Section.
Lubrication
Perform the daily lubrication as required by the
Lubrication Chart.
Pre-start Checks
Check all of oil, coolant and fuel levels.
Refer to the Daily in the Maintenance Section for
more detailed information.
Seat and Seat Belt Checks
Adjust the seat to allow full travel of the levers and
pedals when the operator is seated against the seat
back.
Inspect the belt mounting hardware. Replace any
damaged or worn hardware. Keep the mounting
bolt tight.
Fasten the seat belt before starting the engine.
To Next Page
Loading...