Kato Imer 17VXE - Page 65

2 – 21
OPERA
TION
AL
WAYS set the marked (–) in horizontal
position. If the marked (
I
) of the valve is set in
vertical position, the B port of the double action
does not function efficiently.
CAUTION
Unlocked
Locked
A
port
Actuate
B port
Actuate
Double
Action Pedal
➀
Shift V
alve
Set the mark
(–) in horizontal
position
“A
“ Port
(PF 1 / 2)
(delivery)
“B“ Po
rt (PF 1 / 2)
(return)
(opposite side)
CAUTIO
N
Single action connectors are located on both sides
of the arm (see picture). Connect high pressure
hose (delivery) to the “A” port and low pressure
hose (return) to the “B” port.
2.
DOUBLE ACTION OPERATIO
N
Wren
ch Fork and Others Cont
rols
Switchin
g the attachment hydraulic circuit.
Check the marked position on the shift valve

.
Turn
the valve with a wrench and set the marked (–)
in horizontal position, if necessary.
1)
Unfold the pedal

into two pedal pl
ates
.
2)
Move the lock lever to the
unlocked posi
tion.
To actu
ate the port A:
Push down on the front of the pedal

to
actuate the p
ort A.
To actuate the port B:
Push down on the rear of the pedal

to actuate
the port B.
N
OTE: When the power port is out of service,
ALWAYS set the pedal back to the
neutral position and pedal

lock l
e
v
e
r
 to the LOCKE
D posi
tion.
CAUTIO
N
Single action connectors are located on both sides of
the arm (see picture).
“A
“ Port
(PF 1 / 2)
“B“ Po
rt (PF 1 / 2)
(opposite side)