KBL Tower space 2000 - Page 30

Operating Instructions | KBL Tower space 2000
30
Activates and deactivates the line-in connection
(bench part, right-hand side of the head end) for
units from standard-line level to low loudspeaker
levels (MP3 player, iPod, etc.).
Factory setting: on
㉑
>
> on
> off
AUDIO 06/22
MP3 (Line-In)
Allows for the change-over between pulse-code
and BCD-code mode with the Studio signal pending
and deactivates the external-channel selection.
Factory setting: bcd
㉒
> bcd >
> puls code
> off
AUDIO 07/22
Studio channel selection
If bcd has been preselected, the number of channels
available in the studio is specified here.
Factory setting: 4
㉓
>
> 2
> 4
AUDIO 08/22
Number of studio channels
If this function is active, music is played nonstop,
i.e. also out of tanning sessions.
Factory setting: off
㉔
>
> on
> off
AUDIO 09/22
Music nonstop
Allows for choosing the permanent audio source for
the “Music nonstop” function“.
Factory setting: MP3-internal
㉕
>
> MP3-internal
> Studio Line-In
AUDIO 10/22
Nonstop music source
Sets the volume for the tanning mode.
Factory setting: 6
㉖
>
> 0 .. . 9
AUDIO 11/22
Default volume tanning
Sets the volume for the standby mode.
Factory setting: 3
㉗
>
> 0 .. . 9
AUDIO 12/22
Default volume standby
Presetting the maximum adjustable sound level,
limits the maximum adjustable sound level in the
operating and standby mode.
Factory setting: 9
㉘
>
> 5 .. . 9
AUDIO 13/22
Maximum adjustable volume
Here you can adapt the volume of megaVoice.
Factory setting: -07 dB
㉙
>
> -09 .. . +09 dB
AUDIO 14/22
megaVoice volume adaption