Operating Instructions | KBL tower space 2000
7
2.1 General safety notes
Read the operating instructions before using the tan-
ning device.
This tanning device must be operated with an exter-
nal timer as specified in chapter
Timer controlled
operation
.
NOTE: This tanning device is intended to be uses by
only one adult person at a time. Therefore, only one
(1) pair of protective eyewear is provided with each
KBL tanning device. Use protective eyewear when-
ever the tanning device is operated. Read related
operating instructions in chapter
Guidelines for the
use of protective eyewear
.
Do not tan more than once in a 24 hour period.
Tanning results normally occur after a few sessions
and increase after four (4) weeks of regular expo-
sure. Follow the exposure schedule in accordance
with your skin type as specified in chapter
Exposure
schedule.
Failure to do so may result in overexpo-
sure. However, regardless of how dark an individual
may tan on this tanning device, it will not provide
adequate protection against overexposure to natural
sunlight or UVB tanning devices.
SKIN TYPE II - This is the individual that usually
burns easily and severely, tans minimally or lightly
and peels.
SKIN TYPE III - Often referred to as „AVERAGE“ com-
plexion. Burns moderately and tans about average.
SKIN TYPE IV - This individual burns minimally, tans
easily and above average with each exposure.
SKIN TYPE V - This individual rarely burns, tans eas-
ily and substantially.
FURTHER INSTRUCTIONS
WARNING
No modification of this equipment is allowed.
• Follow all instructions given in this manual. In addi-
tion to that, observe all applicable statutory provi-
sions and regulations, also those applicable in the
country of operation.
• The appliance may only be installed and assem-
bled by specifically trained staff.
• Observe all danger signals and safety signs
attached to the equipment.
• Safety signs must not be removed, and safety
appliances must not be disabled.
• The tanning device may only be operated when in
perfect working condition.
• Never operate the tanning device with the outer
covering removed or with the acrylic panes
removed.
• Pay attention to the load limit of the floor plate
(tower devices only).
• The tanning device operated in the circulating-air
mode may not be connected to an exhaust air sys-
tem.
2.2 Duties of the operator
The manufacturer cannot be held liable for damages or
injuries resulting from improper use of the equipment
or non-observance of these operating instructions.
Only use original spare parts, otherwise operating
authorization and terms of guarantee will become
invalid.
2. Safety notes
To Next Page
Loading...