Rev. 1.00
22585_EDEBDA0252-0318-1_EN
36
KBR multicomp F144-3 6DO/12DO Description of the display window
If you want to activate learning mode, make sure that all previous submenu
parameters have been con gured correctly.
To activate learning mode, press U, change the setting to es by pressing V,
then press X to con rm.
After starting learning mode, active ashes and the time remaining until
the end of the learning cycle is displayed.
NOTE
The auto con guration then sets the stage power automatically, but these val-
ues need to be checked once the learning process has been completed. After
the learning process has been completed, all stages are switched to automatic
mode.
To Next Page
