KBR multisys D2-ESET/MSMT-4 - E-Port Configuration for Modbus TCP

32 pages

To Next Page

To Previous Page

V4.00

25833_EDEBDA0290-0622-1_EN

3.4 E-port conguration for Modbus TCP

For Modbus TCP, the parameters must be set as shown in the gure below. The network

parameters (IP address, mask, gateway, DNS) must be adapted to local circumstances.

NOTE

The UART parameters must be adapted to the local bus parameters. Local port: 502

Several connections to a serial interface, via the TCP, are possible. Replies are only sent to

the enquirer

Software conguration