KBR multisys D2-ESET/MSMT-4 - Box-To-Box Operation; Setting the Multisys D2-ESET -4 in Server Operation

V4.00
25833_EDEBDA0290-0622-1_EN
23
4.1.5 Box-to-Box operation
In Box-to-Box operation, you can establish a logical permanent network connection
between two multisys D2-ESET -4 serial ports. In this operating mode, there is a perma-
nent online connection between the two serial terminals connected. Possible additional
data trac or other network protocols do not inuence the connection. In this operating
mode, a permanent TCP connection between the server and client port is established.
The server port is acting as a TCP client and thus responsible for opening (after congura-
tion or reset) and closing (after deactivating the „Box-to-Box“ operating mode) tasks.
On the network side, there is only multisys D2-ESET -4 data trac using the Box-to-Box
connection if serial reference data is available. There is no data trac excessing the TCP
protocol.
4.1.6 Setting the multisys D2-ESET -4 in server operation
Example: Server IP address 10.66.22.90
Menu 1 Channel 1
NOTE
For the operating mode „Box-to-Box“, only the server port is congured; The client IP
address (remote IP address) and client port number (remote port) are only set at the
server port!
NOTE
The conguration of the serial interface in the 0 Server sub menu has to be made at
both ports.
Input: telnet 10.66.22.90 9999
Input: Enter (within 2 seconds)
Response:
MAC address 00204AA63735
Software version V6.5.0.7 (070919) XPTEXE Press Enter for
Setup Mode
*** basic parameters Hardware: Ethernet TPI
IP addr 10.66.22.90, no gateway set,netmask 255.255.255.0
LAN eBus conguration