KBR multisys D2-ESET/MSMT-4 - Software Configuration

V4.00
25833_EDEBDA0290-0622-1_EN
8
3 Software conguration
The present device is available in a version with Lantronix LAN port (until approx. Dec
2020) or IOT LAN port (from approx. Jan 2021).
There are three options for parameterizing the LAN port for these versions:
1. Using a web browser and the web interface in the LAN port
(Lantronix and IOT Lanport). See under 4.1.4.
2. Using the Telnet program
(described for the execution with the Lantronix LAN port) see point 4.
The connected device then reports under the factory-set IP address 192.168.0.1:
3. Using the IOT program www.hi-ying.com/download-center-1/applications-1/down-
load-item-iotservice (source of supply IOTService).
First the IOT service tool should be installed. After starting the IOT service tool,
the connected network is scanned and the Eports found are displayed.
Procedure: The parameterization with the IOTService Tool:
After installing and starting the IOTService Tool and the connected network is scanned
and the E-Ports found are displayed and can be edited further.
Status
System runing status overview
System State
Product Name
E20
DHCP
Disable
Subnet Mask
255.255.255.0
DNS
0.0.0.0
System Time
NTP Disabled
Remaining RAM
31694
Conguration Protected
Disable
MAC
F0FE6BBA1D69
IP
192.168.0.1
Gateway
0.0.0.0
Firmware Version
1.34.12
Total Running Time
0-Day 23:12:15
Max Block Size
28576
Software conguration