KBR multisys D2-ESET/MSMT-4 - Page 9

V4.00
25833_EDEBDA0290-0622-1_EN
9
NOTE
For security reasons, the IP address of the device should be changed immediately,
to prevent unauthorized persons from accessing the device from outside. In addition,
the device should be password protected (for devices of the multimess series).
System Settings
Change the device system settings
Authentication
admin
admin
User Name
Password
Basic Settings
mysys_BA1D69Host Name
Authentication
192.168.0.1
DHCP
WAN P
255.255.255.0Subnet Mask
0.0.0.0Gateway
0.0.0.0DNS
OFF
NOTE
After selecting the port, you can access the parameterization with „Cong“.
The factory setting is congured to eBus. If Modbus is to be used, proceed as
described under 3.4.
Software conguration