KBR multisys D2-ESET/MSMT-4 - Page 19

V4.00
25833_EDEBDA0290-0622-1_EN
19
LAN eBus conguration
Serial trigger input: disabled
Channel: 1
Match: 00,00
Trigger input1: X
Trigger input2: X
Trigger input3: X
Message:
Priority: L
Min. notication interval: 1 s
Re-notication interval : 0 s
Change Setup:
0Server
1. Channel 1
2. E-mail
3. Expert
4.Security
5. Defaults
6. Exit without save
7. Save and exit Your choice
? 0
IP Address : (000) 10.(000)
66.(000) 22.(000) 98
Set Gateway IP Address (N) N
Netmask: Number of Bits for Host
Part (0=default) (0)8
Change telnet cong password (N)
N
Change Setup:
0 Server
1 Channel 1
3 E-mail
5 Expert
6 Security
7 Factory defaults
8 Exit without save
Save and exit Your choice ? 1
Baudrate (9600) ? 38400
I/F Mode (4C) ?7F
corresponds to 8 data bits,
parity even, 1 stop bit
Flow (00) ?
Port No (10001) ? 8000
ConnectMode (C0) ?
Remote IP Address: (000).(000).
(000).(000)
Remote Port (0) ?
DisConnMode (00) ?
FlushMode (00) ?
DisConnTime (00:00) ?:
SendChar 1 (00) ?
SendChar 2 (00) ?
Change Setup:
0 Server
1 Channel 1
3 E-mail
5 Expert
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice
? 9
Parameters stored ...
Connection to host lost.
You can now make changes and save them
with 9. Now it is ready for operation using
the new network parameters.
The settings for the IP address, the default
gateway and the netmask are made under
the menu item 0 Server. The settings for
the serial interface (KBR - energy bus) are
made under the menu item 1 Channel 1
(eBus-Parameter 38400 Baud,
8 Datenbits, Parity even, 1 Stopbit).