KDK 40BECH - Page 15

安裝方法
HOW TO INSTALL
15
面板組合安裝
2. Installing louver assembly
將過濾 網組合從面板組合拆除。
Remove the filter assembly from the louver assembly.
將過濾 網組合重新安裝回面板組合。
Install the filter assembly back into the louver assembly.
導風板 支架
Baffle plate holder
Louver assembly
面板組 合
提示事 項
Notice
安裝完 成後，請確保導風板支架突出面 板組合約1 mm。
否則可 能導致面板組合變形。
1 After finishing installation, make sure that the baffle .
plate holder protrudes from the louver assembly by
approximately mm.1 Otherwise it may cause the filter
assembly to be deformed
2
將雙層 面板的前面板打開，向上掀即可 打開。
掀開向 上
Liftupward
Openthe frontpanel of the louver assembly
by lifting it upward.
約1 mm
About 1 mm
將面板 組合掛入機體上的掛鉤。
Hang the louver assembly into the hook
on the main body.
Main body
hook
機體掛 鉤
注意
CAUTION
務必用螺絲緊固前面板與 面板底座。
否則前 面板可能會掉落導致受傷。
■Be sure to fasten the front louver and the
louver holder with screws.
Otherwise ,the front panel may fall and
cause injury.
請確保 面板組合及過濾網安 裝到位，否 則可能導致 灰塵、毛髮等異物進入。
2.Make sure that the and filter are installed louver assembly assembly
in place, otherwise foreign matter such as dust and hair may enter.
Insert the screw cover with a slotted screwdriver
and pry the screw cover outward. Fix the louver
assembly to the main body with four M4×8 machine
screws provided in accessory packaging.
用一字 螺絲刀插入螺絲蓋的縫隙，往外 撬開螺絲蓋 。
使用附 件包所提供的4顆M4× 8機械螺絲將 面板組合
固定於 機體。
將撬開 的螺絲蓋重新蓋好，使 螺絲 將面用2顆M4×10機械 ，
。板組合 的前面板固定於面板底座 （請使用金屬桿長 大於
180 mm 的十字 螺絲刀）
Covering the screw cover, fixthefrontpaneloflouver
assemblyto louverholderbyusingthetwo machine
screw M4×10.(Please use a screwdriver which metal
rod is longer than 180 mm )
Machine screw M4×10
機械螺 絲M4×10
Machine screw
M4×8
機械螺 絲
M4×8
螺絲蓋
Screw cover
請注意 不要刮花面板組合。
Please be careful not to scratch the .louverassembly
提示事 項
Notice