Need help?Do you have a question about the KEB COMBIVERT 18F5 Series and is the answer not in the manual?
General| Category | Inverter |
|---|---|
| Protection Class | IP20 |
| Enclosure Rating | IP20 |
| Series | COMBIVERT 18F5 |
| Input Voltage | 3 AC 380 ... 480 V |
| Output Voltage | 0-480V AC |
| Output Frequency | 0-400Hz |
| Control Method | V/f control, vector control |
| Communication Interfaces | CANopen, Profibus |
| Protection Features | Overcurrent, overvoltage, undervoltage, overtemperature, short circuit |
| Cooling Method | Forced air |
| Storage Temperature | -25 ... +70 °C |
| Humidity | 5-95% (non-condensing) |
Explains hazard warning signals and their meanings.
Lists additional symbols used in the documentation.
Covers legal compliance, warranty terms, and manufacturer liability.
Details how to obtain support and copyright usage rights.
Defines qualified personnel and the manual's intended use.
Guidelines for safe handling, storage, and operation of the unit.
Procedures and warnings for proper physical installation.
Safety instructions and requirements for electrical wiring.
Notes on EMC compliance and voltage testing procedures.
Instructions for initial operation, ongoing use, and routine maintenance.
Guidelines for authorized repairs and proper product disposal.
Lists key functionalities and necessary operational conditions.
Details intended use, potential risks, and unintended operations.
Explanation of the product's part code configuration.
Specifies environmental parameters for storage, transport, and operation.
Defines vibration, shock limits, and contamination classes.
Covers device classification and electromagnetic compatibility levels.
Details device specifications including input/output parameters.
Explains overload behavior and lists available accessories.
Information on common mode filters, sine-wave EMC filters, and DC fuses.
Details precharging resistors and refers to manuals for dimensions.
Guidelines for installing in a control cabinet for EMC compliance.
General instructions for proper physical installation and grounding.
Describes the function of input terminals on the drive converter.
Details terminal assignments for different housing types.
Specifies cable sizes and torque values for terminal connections.
Information on external fan power supply for specific housings.
Explains temperature sensing and use of KTY/PTC input modes.
Diagrams of input and pre-charging circuit configurations.
Introduction to circuit diagrams for the AIC system.
Circuit diagrams for power units with AIC/LCL and common mode filters.
Circuit diagrams for master-slave operation and the control circuit.
Explains the operational sequence and flow chart of the AIC system.
Overview of the control board, terminals, and their assignments.
Recommendations for control connection and wiring for digital inputs.
Wiring for analog inputs and external power supply connection.
Wiring diagrams for digital and analog output signals.
Instructions for operating the unit without or with a digital operator.
Navigating menus, adjusting parameters, and managing passwords.
Overview of the interface operator and diagnostic connections.
Details for connecting and wiring RS232 and RS485 interfaces.
Wiring diagrams for RS485 and information on the remote control operator.
Guidance on dimensioning the COMBIVERT F5 AIC units.
Detailed specifications for drive converters and F5 AIC devices.
Procedures for installing liquid-cooled units and heat sink specifications.
Recommendations for cooling circuit materials and coolant properties.
Defines permissible coolant temperatures and warns about condensation.
Guidelines and diagrams for connecting cooling systems.
Procedure for safely decommissioning the cooling circuit.
To Next Page