Need help?Do you have a question about the KEB F6 and is the answer not in the manual?
General| Category | Inverter |
|---|---|
| Protection Class | IP20 |
| Communication Interfaces | PROFIBUS, CANopen, RS485 |
| Operating Temperature | -10°C to +50°C |
| Series | F6 |
| Output Frequency | 0 Hz to 600 Hz |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Short circuit |
| Humidity | 5% to 95% (non-condensing) |
| Altitude | Up to 1000 m above sea level |
| Control Modes | Sensorless vector control |
| Storage Temperature | -25°C to +70°C |
Outlines essential safety measures for handling the device.
Provides guidance for the safe installation of the F6 Elevator Drive.
Specifies required maintenance tasks and safety precautions.
Details the key technical features and capabilities of the F6 Elevator Drive.
Explains the structure and identification of the F6 Elevator Drive model number.
Describes the factory preconfigured functions of the safety module.
Details the safety inputs and outputs of the F6 Drive.
Identifies and describes the drive's connection interfaces and control elements.
Details motor monitoring functions for temperature and brake control.
Describes the 28-pole pluggable terminal strip X2A.
Details the two universal encoder interfaces.
Explains the function and status indicated by the LEDs.
Explains how to use digital inputs for selecting up to five different speeds.
Details binary-coded inputs for selecting up to seven speeds.
Provides an overview of serial speed control using DIN66019II protocol.
Describes the KEB Elevator LCD operator for user interface.
Explains how to navigate menus and select values using the LCD operator.
Shows two methods for adjusting parameters on the F6 using the LCD operator.
Guides on connecting the drive using the LCD operator or KEB Elevator App.
Focuses on essential parameters for drive operation and motor function.
Guides through motor, encoder, and inertia learning procedures.
Guides on running the motor at inspection and automatic speeds.
Provides guidance on adjusting parameters to eliminate ride quality issues.
Lists and describes the different parameter groups available for adjustment.
Defines parameters for motor values and protection settings.
Details parameters for encoder settings and scaling.
Covers parameters related to machine data like sheave diameter and roping ratio.
Explains parameters for adjusting speed, acceleration, and jerk rates.
Covers automatic tuning parameters, system inertia, and motor data.
Details advanced adjustment parameters for motor gains and pre-torque.
Covers parameters for viewing diagnostics and drive status.
Defines parameters for serial communication and data settings.
Lists necessary accessories for using Combivis software.
Provides basic instructions on operating Combivis software.
Describes uploading and downloading parameters using Combivis.
Covers essential setup parameters like system units and motor type.
Defines parameters for motor values and protection settings.
Explains parameters for adjusting speed, acceleration, and jerk rates.
Details advanced adjustment parameters for motor gains and pre-torque.
Details parameters for encoder settings and scaling.
Provides CE and UL marking information and compliance details.
To Next Page