KEB F6 - Product Features

Product Description
© 2024 KEB America, Inc.
31
2.3 Product Features
This document describes the power units of the following devices:
Device Type:
Elevator Motor Control
Series:
F6
Power Range:
18.5 kW / 230 V
4...55 kW / 400 V / 480 V
Housings:
2, 3, 4, 6
The F6 Elevator Drive is characterized by the following features:
• Operation of three-phase asynchronous motors and three-phase synchronous
motors, in operating modes open-loop or closed-loop with and without speed
feedback
• The following fieldbus systems are supported:
o KEB DIN66019II
o CAN
• System-overlapping operating concept
• Wide operating temperature range
• Low switching losses by IGBT power unit
• Low noise development due to high switching frequencies
• Different heat sink concepts
• Temperature-controlled fan (replaceable)
• Oversized IGBT power modules for long life Elevator duty
• General protection functions of the series against overcurrent, overvoltage,
ground fault and overtemperature
• Analog inputs and outputs, digital inputs and outputs, relay output (potential-free),
brake control and -supply, motor protection by I²t, KTY- or PTC input, two encoder
interfaces, diagnostic interface, fieldbus interface (depending on the control board)
• Integrated safety function according to EN 61800-5-2
• Integrated elevator functions according to EN81 and A17.1.