7 Initial Start-Up
7.1 Step 1: Connecting to the Drive
7.1.1 LCD Operator
The LCD Operator can be used to interface with the F6 drive. The LCD operator can
access or change drive parameters stored in the drive. The operator can also store all
elevator parameters. For more information regarding how to use the operator, refer to
the LCD Operator section.
7.1.1.1 Drive at Defaulted State (Never programmed)
If the drive is in a defaulted state, the user will be prompted to program the drive
manually. Press ENTER, then F1 to manually program the drive. For further information,
refer to section Step 2: Programming the Drive.
7.1.2 KEB Elevator Application
The KEB Elevator App can also be used to program the F6 drive. To connect to the drive
via the KEB Elevator App, the KEB Bluetooth Dongle is required. The app will connect via
Bluetooth and programming can be done via the app. The app can also download and
save parameters to/from the drive. For further instruction, refer to the KEB Elevator
Support page below. You can also contact a KEB elevator engineer at +1 952-224-1400
or email elevator@kebamerica.com.
To Next Page
Loading...
