KEB COMBIVERT F5 Installation Guideline

15
X2A
5
7
8
10
11
14
15
16
20
22
24
25
26
27
28
29
+
1
U
Installation and Connection
3.4.2 Connection of the control terminal strip
Set value signal
0...±10 V DC
To avoid interferences a separate shielding must be provided for analog and digital control
lines. Depending on the use of the relay outputs, an extra shielding is to be used, too.
In case of inductive load on the relay outputs a protective wiring must be provided (e.g.
free-wheeling diode)!
max. 30 V / 0.01...1 A DC
1
8
+
1
7
8
Current signal
0...20 mA
4...20 mA
not at A- and B-
housings
Set value
potentiometer
3...10 kOhm
Analog output
±10 V DC /
max.5 mA
max. 30 V / 0.01...1 A DC

KEB COMBIVERT F5 Specifications

General

Category	DC Drives
Enclosure Rating	IP20
Control Mode	Vector Control, V/f Control
Protection	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Fieldbus Communication	PROFIBUS, CANopen
Communication Interfaces	RS-485
Input Voltage	380-480V AC
Cooling Method	Forced air cooling (fan)