Need help?Do you have a question about the KEB COMBIVERT S4 and is the answer not in the manual?
Details safety precautions regarding moving and rotating parts of the servo system.
Warns about high operating temperatures of the servo motor housing and braking resistor.
Provides essential instructions for safe and trouble-free connection of the servo system.
Specifies permissible limit values for temperature and humidity for operation and storage.
Outlines general guidelines for installing the servo controller and motor safely.
Presents detailed technical specifications for the 230 V class servo motors and controllers.
Presents detailed technical specifications for the 400 V class servo motors and controllers.
Illustrates the torque-speed curves for various servo motor sizes and speeds.
Details the wiring diagram for a 1-phase 230 V servo system connection.
Details the wiring diagram for a 3-phase 230 V / 400 V servo system connection.
Details the functions of terminals on the control terminal strip X2, including I/O and power.
Provides a table listing all parameters, their ranges, resolutions, and factory settings.
Describes how error messages are displayed and how to reset them.
Defines the parameter for setting the time to accelerate from 0 to rated speed.
Defines the parameter for setting the time to decelerate from rated speed to 0.
Specifies the parameter used to define the maximum permissible torque of the drive.
Determines the drive's response to an external fault condition.
Lists error codes displayed on the unit and their corresponding fault descriptions.
Provides a table of possible causes for faults and recommended remedies.
To Next Page
General