KC-P30 Connections and wiring
Installation manual V3.28
33
© KEBA
6) Pull out the screwdriver straight.
7) Repeat these steps for the other connection wires.
The charging station is connected to the power supply.
The charging station is set to 10 A in the delivery state. In order to adapt the
maximum current to the installed line circuit breaker, a configuration via the
DIP switches is necessary. For details, see 8.1 DIP switch settings.
7.3.3 Electrical connection to special systems of AC power supply
Information
The charging station can in principle be connected to TN, TT and IT sys-
tems of AC power supply networks. Pay attention to the restrictions of your
vehicle manufacturer.
We recommend connecting the charging station in delta networks without
upstream transformer only with single phase. A three-phase connection in
delta networks should only take place with an upstream transformer ("trian-
gle-to-star converter").
To Next Page
Loading...
