KC-P30 Mounting and installation instructions
Installation manual V3.28
25
© KEBA
6.4 Mounting the charging station
The charging station must be prepared for this before mounting. To do this,
proceed as follows:
1) Unscrew the two screws on the bottom side of the housing cover.
2) Lift the housing cover at bottom max. 1 cm 1 and then push upwards 2.
3) Loosen the four screws of the connection panel cover and remove the
connection panel cover upwards.
4) Loosen the two screws of the terminal cover and remove the terminal
cover upwards.
5) Place the charging station on a stable surface.
6) Using a hammer and flat-head screwdriver, gently knock out the re-
quired cable insertion openings
− Surface-mounting cable insertion: Cable insertion openings on the top
side
− Flush-mounting cable insertion: Cable insertion openings on the back
side
To Next Page
Loading...
